License Plate Holder Chrome Front 44.5x10.5cm

Holder for the front license plate.
Front license plate holder.
Dimensions: 44.5 cm x 10.5 cm.

The number plate itself is not a thing of beauty. But unfortunately it is required worldwide that your car has a clear and legible license plate, whether we like it or not.

With this chrome-plated license plate holder you can turn a boring plate into a showpiece, without having to drill through the plate, because the fastening to your car is behind your plate.

To comply with all European guidelines, these plate holders are made with great precision, exactly to the dimensions of the license plate.

Fitting: The frame consists of two parts. The screws in the connectors are unscrewed from the top and slid out of the connectors. Loosen the other screws as far as possible, so that the plate is not blocked during fitting. Slide the plate into the lower part (where the screws are still fitted), followed by the upper part. Check that the screw holes are perfectly aligned. If so, you can retighten and tighten the screws. If the holes do not match 100%, there are burrs or other irregularities on the edge of your plate that prevent it from sliding in far enough. Do not use force, but file the irregularities and/or burrs on the edges of the plate and you will see that the screw holes match.

Caution! Measure your license plate before ordering. There have been several sizes over the years; only the largest sizes are standardized in Europe.