License Plate Holder Chrome Rear 27.5x19.5cm

Rear license plate holder.
Dimensions: 27.5 cm x 19.5 cm.

The license plate itself is not a thing of beauty. But unfortunately it is required worldwide that your car is fitted with a clear and legible license plate, whether we like it or not.

With this chrome license plate holder you can turn a boring plate into a showpiece, without having to drill through the plate, as the mounting to your car is behind your license plate.

To comply with all European guidelines, these plate holders are made with great precision, exactly to the dimensions of the plate.

Fitting: The frame consists of two parts. The bolts in the connectors are screwed out from the top and pushed out of the connectors. Loosen the other bolts as far as possible so the plate is not blocked during fitting. Slide the plate into the lower part (where the bolts are still fitted), followed by the upper part. Check that the bolt holes are perfectly aligned. If so, you can tighten the bolts. If the holes do not match 100%, there are burrs or other irregularities on the edge of your plate that prevent the plate from sliding far enough. Do not use force, but file the irregularities and/or burrs on the edges of the plate and you will see that the bolt holes match.

Caution! Measure your license plate before ordering. There have been several sizes over the years; only the largest sizes are standardised in Europe.