- Order number: 5004591
Pro Street reinforced gearbox for IRS (semi-trailing arm) axle.
Final drive ratio: 8:31 (3.875).
IRS axle.
VW Beetle.
Type 14 Karmann Ghia.
With light tuning you can use the standard gearbox without problems, although it is advisable to use a gearbox with a final drive of 8:31 (3.875). This was fitted by Volkswagen as standard in the S versions (with a 1600 cc engine). With this gear ratio all gears are longer, so a higher top speed is reached.
If the power increases considerably, a standard gearbox can cause problems. It can take a lot, but you have to bear in mind that it is designed for 50 hp. The Pro Street gearboxes are reinforced at numerous points and can be used for heavier duties such as off-road racing, drag racing and circuit racing. The Pro Street gearboxes are fitted with:
- Reinforced side cover (more information: 1493)
- Reinforced differential, fitted with four spider gears (more information: 1420)
- Gears are secured with hardened locking keys
- Connecting rods made of steel instead of cast
- 8:31 final drive (3.875)
- Fitted with a universal gearbox housing *
* Due to the universal gearbox housing, the gearbox can be fitted in all years of Beetle and Karmann Ghia and is intended for a floating thrust bearing; if necessary another thrust bearing with the corresponding pressure group has to be fitted (for more information see the standard reconditioned gearboxes 1490).
In addition to the modifications mentioned above, the gearboxes have been expertly reconditioned, completely dismantled, cleaned, inspected and fitted with new synchroniser rings, shift fork bushes and gaskets. We want to make it as easy as possible, so we do not need a trade-in. It can happen that you need a different thrust bearing with pressure group from the one originally fitted.
Note on the reconditioning:
The gears of the various speeds are fitted with an additional ring gear that ensures the synchronisation and transmission of the power of the gear being selected. Many reconditioned gearboxes have lost some of their teeth, whereas this is not the case with the original. This adjustment is, however, made deliberately to avoid shifting problems. Gears are originally fitted with thin and thick teeth on a ring gear. Only the thickest teeth are loaded and subject to wear. If these teeth are too worn, the gearbox tends to jump out of gear or you can no longer shift smoothly. To avoid this, during reconditioning the thicker teeth are removed so that the remaining thinner, still newer teeth can take over these tasks. This is of course only done if these teeth are so worn that it cannot be guaranteed they will last a whole gearbox life without problems. Fitting new ring gears is unfortunately not possible, as these are simply not available. The "new" gearbox is not weaker than the original, because the number of thicker teeth is always equal to or smaller than the number of thinner teeth. This method is used by many reconditioning companies and is now a recognised way of solving this problem.
4590 : version with swing axle (swing axle)
4591 : version with semi-trailing arm (IRS axle)
Swing axles are identified by 1 drive sleeve fitted on the gearbox side; IRS axles are loose shafts with drive sleeves on both sides.