- Order number: 5001492
Fully reconditioned gearbox for IRS (independent rear suspension) axle.
Final drive ratio: 8:31 (3.875).
IRS axle.
A gearbox does not last forever. Various parts can wear out after a while, making gear changes difficult or causing noise while driving. You can open the gearbox yourself and fix the problem, but it is often not an easy task. A ready-made solution is a fully reconditioned gearbox with a final drive of 8:33 (4.125), 8:35 (4.375) or 8:31 (3.875). The latter has always been fitted by Volkswagen on models that came standard with a 1600 cc engine. This type of final drive is very popular with everyone who has fitted an engine of 1600 cc or more. Thanks to this ratio all gears are longer, resulting in a higher top speed. The revs are lower than before above a certain speed, resulting in less engine noise in the passenger compartment. If you now have an engine of 1200, 1300 or 1500 cc fitted, you can still fit an 8:31 (3.875) gearbox without problems, but bear in mind that the torque will be much lower and you will have to accelerate longer before reaching the desired speed.
All reconditioned gearboxes are supplied complete, except for mounting rubbers, release bearing and oil.
All gearboxes are fully synchronised. If you have a car up to model year 7/1960, it is also possible to fit it with a conversion adapter which you can buy in our shop.
Note on the reconditioning:
The gears of the various speeds are fitted with an additional ring gear that ensures the synchronisation and transmission of the power of the gear being selected. Many reconditioned gearboxes have lost some of their teeth, whereas this is not the case with the original. This adjustment is, however, made deliberately to avoid shifting problems. Gears are originally fitted with thin and thick teeth on a ring gear. Only the thickest teeth are loaded and subject to wear. If these teeth are too worn, the gearbox tends to jump out of gear or you can no longer shift smoothly. To avoid this, during reconditioning the thicker teeth are removed so that the remaining thinner, still newer teeth can take over these tasks. This is of course only done if these teeth are so worn that it cannot be guaranteed they will last a whole gearbox life without problems. Fitting new ring gears is unfortunately not possible, as these are simply not available. The "new" gearbox is not weaker than the original, because the number of thicker teeth is always equal to or smaller than the number of thinner teeth. This method is used by many reconditioning companies and is now a recognised way of solving this problem.
All gearboxes mentioned are applicable to the Volkswagen Beetle and Karmann Ghia from 8/1960 (can also be used before, see text), and it is not necessary to return your old gearbox.
If your car is older than 7/1960, you need a conversion adapter to fit the gearbox. It is advisable to replace the release bearing with pressure plate, clutch disc and mounting rubbers straight away, as well as the drive sleeves on the swing axle version. Do not forget to order the correct oil. All gearboxes are supplied without oil. You can buy the oil separately in our shop.
Pro-Street gearboxes
With a slightly stronger engine you can use the standard gearbox without problems, although it is advisable to use a gearbox with a final drive of 8:31 (3.875). If the power increases considerably, a standard gearbox can cause problems. Pro-Street gearboxes are reinforced in many respects and can be used for heavier duties such as off-road racing, drag racing, circuit racing, etc.
The gearbox is built specially for you after ordering, so the right of withdrawal is excluded.